Electronic Parking Brake Control Module FIT 2014-2018 Jeep Cherokee FIT 2015-2017 Chrysler 200 EPB ECU 68330407AA 68265141AD

Vehicle Compatibility Matrix (EPB Equipped Models ONLY): FIT 2014-2018 Jeep Cherokee (Latitude, Limited, Trailhawk, Sport) FIT 2015-2017 Chrysler 200 (C, S, LX, Limited) Note: Programming/Configuration is required after installation for signal synchronization. Technical Specifications & Physical Evidence: Module Type: Electronic Parking Brake (EPB) Control Unit Housing Material: High-Temperature Vibration-Resistant Polymer Protocol Compatibility: CAN-bus Communication Ready OE Part Interchange: 68330407AA, 68438392AA, 68148902AD, 68148902AE, 68148902AF, 68265141AD, 68265141AE. Technical Installation & Service Protocol: This parking brake ECU is a precision electronic hardware component. Before integration, ensure the vehicle battery is fully charged and the rear brake calipers are in the service position. After mounting the hardware, a PROXI alignment or VIN synchronization procedure must be performed using an OBD-II diagnostic tool to restore factory handling characteristics. Avoid exposure to water or excessive moisture at the connector interface during installation to maintain signal integrity.

• FIT 2014, 2015, 2016, 2017, 2018 Jeep Cherokee; FIT 2015, 2016, 2017 Chrysler 200. This hardware is application-specific for models equipped with the Electronic Parking Brake (EPB) system. Verify your original module's part number matches the OE references before purchase.
• This Electronic Control Unit (ECU) integrates an automotive-grade microprocessor and a high-density circuit board treated for environmental exposure. The assembly is engineered to maintain a closed-loop feedback system between the brake switch and the rear calipers, ensuring direct-fit integration with the factory wiring harness.
• Designed to address erratic signal feedback and inconsistent voltage data in the parking brake circuit. This module restores factory-specified engagement characteristics and maintains proper signal geometry for the electronic calipers, addressing mechanical play in the brake actuator communication loop.
• The hardware housing is constructed from reinforced heat-resistant polymer and undergoes cycles tested validation for vibration resistance. Each unit is precision-engineered to match the factory mounting bosses and matches OE specifications for bus communication protocols (CAN-bus data alignment).
• Professional installation is required; this module may require VIN programming or a PROXI alignment procedure using a diagnostic scanner to ensure full system integration. Do not attempt installation without proper electronic calibration tools. Replaces OE# 68330407AA, 68438392AA, 68148902AD, 68265141AD.